Adjustable Claw Hammer with 16 oz Carbon-Steel Head
Free shipping on every order
Take 10% off when you buy 2 or more
Details
This adjustable claw hammer pulls nails that a fixed claw cannot reach. The claw locks into four positions, and a magnetic slot holds a nail so you can start it without pinching it between your fingers. It can take the place of a separate cat's paw or pry bar for many jobs.
Key features
- 16 oz forged carbon-steel head
- Steel handle with a shock-absorbing, slip-resistant grip
- Claw adjusts to four positions: straight, 90-degree hook, tucked flat, and folded
- Steel pivot pin with a spring detent and push button
- Magnetic nail slot built into the face
- Approximately 14 inches long and about 2 pounds in hand
- Suitable for framing, finish, roofing, and brad steel nails
How the adjustable claw works
Press the button to move the claw into the position the task requires. The adjustable angle helps the claw reach nails and tight spaces that a straight claw may not be able to access.
The magnetic slot holds a nail against the hammer face, so you can position and start the nail with one hand while the other stays free.
Starting nails with one hand
The magnet keeps the nail in place while you position the hammer. Set the nail, make the first strike, and avoid holding it with your fingers.
Pulling nails
To remove a nail, place the claw over the nail head, hook it from above, and pull the handle back. The claw can be set to the angle that gives you the clearest access.
Four claw positions
Use the straight position for standard nail pulling. Set the claw at 90 degrees when you need to reach behind an edge or work in a restricted area. Tuck it flat under brackets and lips, or fold it away for compact storage.
Common uses
- Car repairs: CV axles, control-arm bolts that will not line up, and engine-mount brackets
- Decks and fences: nails in the corner of a board, fence staples, and old deck screws that have gone soft
- Framing and demolition: nails behind studs, and trim you want to reuse without splitting it
- Brackets and tight spaces: the tucked-flat claw slides under a bracket or lip where a longer pry tool will not fit
Using the claw on a CV axle
Set the claw to the angle that suits the job. Hook it behind the lip of the inner joint housing, rest the hammer head against the case, and pull square. When the joint is held by a standard spring clip, this may be all it takes.
This is a hammer rather than a press or a puller. Pressed-in ball joints, and parts rusted solidly in place, need a press or a puller.
Care and storage
Wipe the hammer clean after use and store it in a dry toolbox or other dry location. Keep the pivot area free of dirt and debris so the button, spring detent and claw positions work smoothly. Fold the claw for compact storage when appropriate.
What is included
- One adjustable claw hammer
Packaging may vary.