Leathos Horse Gear Hole Puncher with Six Interchangeable Cutters
Free shipping on every order
Take 10% off when you buy 2 or more
Details
Horse Gear Hole Puncher
This equestrian hole puncher adds a clean, single hole to leather tack in a minute, at the barn, without a hammer, a nail or a trip to the saddler. It is designed for headcollars, halters, bridles, stirrup leathers, spur straps and chaps.

How it works
The Spring-Spin-Cut mechanism makes each hole. Set the tip on your mark and press down with one hand. The cutter spins as it descends and slices the hole clean, with no hammering and no squeezing. Then it springs back up, ready for the next hole.
Earlier methods, such as heating a nail, using a punch and mallet, squeezing with pliers, or taking the item to a saddler, are replaced by this tool. A rotary punch can break when leaned on and can leave circle marks on good leather.

Interchangeable tips
The tool includes six cutters: 1.5 mm, 2 mm, 2.5 mm, 3 mm, 3.5 mm and 4 mm. Pick the tip that matches the tongue of your buckle or the holes already in the strap.
Doubled or stitched leather takes extra presses. Give it a moment and keep the strap flat on the mat.


Smart waste channel
A built-in channel pushes out cut material as the cutter fills, which keeps the tip clear while you work. You can punch the next hole and the next without stopping.

Build and durability
The tool is made from strong metal and smooth hardwood, with a palm-driven design that does not strain your hand. It is built as a serviceable tool: the tips can be sharpened when they dull, and the tool stays in service. It is small enough to keep in the tack box or grooming tote.

What you can fix with it
- Headcollars and halters: Take in a headcollar that sits between sizes, or fit a new buckle or a nameplate, with one hole where the fit needs it.
- Bridle cheekpieces and nosebands: Add a hole between the factory ones, for example on a cheekpiece that is one hole too long or a noseband that sits too low.
- Stirrup leathers: Shorten a child's leathers before a lesson, or take in a pair that has run out of holes. This can be done at the barn with no one else needed.
- Spur straps, chaps and repairs: Add one clean hole to a worn strap, a spur strap or a pair of chaps. The tool goes back in the tack box afterwards.
What's in the box
- Hole puncher tool
- Six interchangeable cutters: 1.5 mm, 2 mm, 2.5 mm, 3 mm, 3.5 mm and 4 mm